How do you cut stone veneer?
Manufactured stone veneer thickness.
Thin profile manufactured stone veneer is never more than 2 inches thick.
Manufactured cultured stacked stone veneer lowes:
Standard light fixture gray, nightfall™, sable (shown), taupe 8 x 10 x 1 ¾ electrical box:
For wide joints, more mortar may need to be placed on the back of the stone.
Be aware that increasing the amount of mortar on the back of the stone unit.
Single receptacle gray, nightfall™, sable, taupe (shown) 6 x 8 x 1 ¾ electrical box:
The thickness of typical thin stone veneer was three centimeters by.
The reduced thickness makes it easy for you to install our stone veneers using traditional masonry methods and perfect for interior or exterior application.
Finally, the weight of the units cannot exceed 15 lb/sqft2.
⅝” to 1” (2½”wide x 8” length)
Veneer stone face sizes can be as large as 14 inches in diameter.
Our thin stone veneer products consist of quarried and weathered natural stone that has been cut thin (1 inch thick) and weigh less than 15 lbs per sf (square foot).
Use it for interior or exterior projects including stone siding, fireplaces, foundations, and any other architectural construction project that demands the finest surface covering.
Use a combination of both methods.
1 ⅛” to 2½” a.
Manufactured stone & brick veneer properties:
For thin joints, less mortar should to be used.
Joint width proper joint width depends on the type of stone being used and the desired appearance.